JVC GET0199-001A Instructions Manual page 122

Removing the unit
Before removing the unit, release the rear section.
1
B
When using the optional stay /
Fire wall
Dashboard
PRECAUTIONS on power supply and speaker connections:
• DO NOT connect the speaker leads of the power cord to the car battery; otherwise, the
unit will be seriously damaged.
• BEFORE connecting the speaker leads of the power cord to the speakers, check the speaker
wiring in your car.
+ +
L
-
-
+
+
R
-
-
TROUBLESHOOTING
• The fuse blows.
* Are the red and black leads connected correctly?
• Power cannot be turned on.
* Is the yellow lead connected?
• No sound from the speakers.
* Is the speaker output lead short-circuited?
• Sound is distorted.
* Is the speaker output lead grounded?
* Are the "–" terminals of L and R speakers grounded in common?
• Noise interfere with sounds.
* Is the rear ground terminal connected to the car's chassis using shorter and thicker cords?
• Unit becomes hot.
* Is the speaker output lead grounded?
* Are the "–" terminals of L and R speakers grounded in common?
2
3
Stay (option)
F
G
I
Screw (option)
C
Install the unit at an angle of less than 30˚.
4
D
When installing the unit without using the sleeve /
In a Toyota for example, first remove the car radio and install the unit in its place.
Flat type screws (M5 x 8 mm)*
Bracket*
Pocket
Note : When installing the unit on the mounting bracket, make sure to use the 8 mm-long
screws. If longer screws are used, they could damage the unit.
•
•
+ +
L
-
-
+
+
R
-
-
•
*
•
*
•
*
•
*
*
•
*
•
*
*
2
Insert the two handles, then pull them as
illustrated so that the unit can be
removed.
*
*
Flat type screws (M5 x 8 mm)*
Bracket*
*
H
* Not included with this unit.
*
*
+
+
L
-
-
+
+
R
-
-