Assigning Names To Cds - JVC GET0199-001A Instructions Manual

Assigning names to CDs

You can assign names to CDs (both in this unit
and in the CD changer).
After assigning a name, it will appears on the
display when you select the source.
Source Maximum number of characters
CDs* Up to 32 characters (up to 40 discs)
*
You cannot assign a name to a CD Text or an
MP3/WMA disc.
1
Select a CD you want to assign a
name to.
When you select CD as the source, the
power automatically comes on.
2
While pressing DISP (display), press
and hold SEL (select) for more than
2 seconds.
3
Select the character set you want
while the first character position is
flashing.
Each time you press the button,
the character set changes as
follows:
(A – Z: capital)
(Russian letters:
lower case)
(Russian letters:
upper case)
4
5
6
7
To erase the input characters
To erase all the characters at a time, press and
hold DISP (display) for more than 1 second as
described in the procedure above.
Notes:
• When you try to assign a name to a 41st disc,
• When the CD changer is connected, you can assign
(a – z: small)
(0 – 9: numbers,
and symbols)
Select a character.
• About the available
Move the cursor to the next
(or previous) character position.
Repeat steps 3 to 5 until you finish
entering the name.
Finish the procedure while the last
selected character is flashing.
"NAME FULL" appears and you cannot enter the
text entry mode. In this case, delete unwanted
names before assignment.
names to CDs in the CD changer. These names can
also be shown on the display if you insert the CDs
in this unit.
characters, see page
52.
39