Advertisement
Quick Links
ZERO WASTE REVERSE OSMOSIS RETROFIT KIT
Solenoid valve, electric pump
and pressure switch assembly
Check valves and flow
restrictor assembly
Transformer
PARTS BAG
Rerverse osmosis system water return valve for hot water
line with brass insert, delrin sleeve and brass compression
nut. Four Pump mounting screws, drain plug and four plas-
tic nuts.
Watts Premier, Inc.
1725 W. Williams Dr
Phoenix, AZ 85027
WATTS
INSTALLATION INSTRUCTIONS
Parts Included in the Kit
4' of Green Tube
4' of Black Tube
Recommended Tools for Installation
Sharp knife
5/8" wrench
Philips screwdriver / Screw gun
Solenoid
Valve
Electric
Pump
Check Valves
Flow Restrictor
Channel lock
Cressant wrench
page 1
Pressure
Switch
Wire Harness for
valve & Pump
Adapta-valve
Phone: 800-752-5582
Fax: 623-931-0191
www.wattspremier.com
Rev 10/15/02
Advertisement
Related Manuals for Watts Premier ZERO WASTE RETRO
Summary of Contents for Watts Premier ZERO WASTE RETRO
- Page 1 Four Pump mounting screws, drain plug and four plas- tic nuts. Recommended Tools for Installation Sharp knife Channel lock 5/8” wrench Cressant wrench Philips screwdriver / Screw gun Watts Premier, Inc. Phone: 800-752-5582 1725 W. Williams Dr Fax: 623-931-0191 Phoenix, AZ 85027 www.wattspremier.com page 1 Rev 10/15/02...
- Page 2 Installation Steps for Zero Waste Reverse Osmosis Retrofit Kit Note: RO unit must be installed a mimimun of 25 feet from hot water heater. Step 1 Turn off the hot (#1 in Fig. 1) and cold (#2 in Fig. 1) water supply lines to the sink at the angle stop valves.
- Page 3 Reverse Osmosis Water Faucet Standard Sink Water Faucet Standard Sink Drain Membrane Flow Restrictor Serial # NSF Premier LEGEND Blue Tube = Reverse Osmosis Water Red Tube = System to Air Gap Water Reverse Osmosis Storage Tank Black Tube = Air Gap to Drain Water Green Tube = Incoming &...
- Page 4 Shut down procedure for filter and membrane maintenance Step 1 Turn off hot and cold water supply lines, (close ice maker valve if it applies). Step 2 Unplug the pump from electrical outlet. Step 3 Open RO faucet to drain tank, leave faucet open. If unit has a ball valve on tank close the ball valve and tank does not have to be emptied.