SHENZHEN ENCOM ELECTRIC TECHNOLOGIES CO. EDS1000 series Service Manual page 100

www.enc.net.cn/en Tel/Fax:86-755-26984485/26985120
30 Run command channel selection 2
32 Swing frequency runin
34 interior counter clearing end
36 Interior timer clearing end
Pulse frequency input(only effective for
38
X7,X8)
40 Reserved
42 Reserved
Now explain listed function in Table 6-2 as follows:
1~4: Multi-step speed control terminal. Can set 15 step speed run
frequency by choosing ON/OFF combination of these function terminal.
Table 6-3 multi-step speed run selection table
K
4
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
Above multi-step frequency can be used in multi-step speed run and simple PLC
run, please see below an example of multi-step speed run:
We now define control terminal X1, X2, X3, separately as follows:
After set F5.00=1, F5.01=2, F5.03=3, X1, X2, X3,
multi-step run，as shown in Fig.6-24.
K K
3 2
OFF OFF
OFF OFF
OFF ON
OFF ON
ON OFF
ON OFF
ON ON
ON ON
6 Detailed function description
31 Run command channel selection 3
33 External interruption input
35 interior counter triggering end
37 interior timer triggering end
Reserved
39
41 Reserved
K
1
OFF Common run frequency
ON Multi-step frequency 1
OFF Multi-step frequency 2
ON Multi-step frequency 3
OFF Multi-step frequency 4
ON Multi-step frequency 5
OFF Multi-step frequency 6
ON Multi-step frequency 7
are used for realizing
Frequency setting
91
91