Culligan Platinum Series 9" Owner's Manual page 11

Programming
The Culligan AccuSoft circuit board controls all of the softener functions. These settings are
® ®
programmed at the time of installation. The following is a list of all the microprocessor func-
tions, in the event that any of the settings need to be adjusted. If a small padlock icon appears in
the lower right corner of the display, the microprocessor settings are locked and only the Time-
of-Day setting can be adjusted, call your Culligan Dealer if setting changes are
required.
1. With a flashing or blank display, pressing the status
button twice will move to the Time-of-Day adjust-
ment. A number "1" will appear at the bottom of the
display while in this mode.
2. Press status again, this displays the Time-of-Regenera-
tion. A number "2" will appear at the bottom of the
display while in this mode.
3. Press status again, the number "3" will appear at the
bottom of the display along with the letter "A" to the
right of the display. This setting is not used.
4. Pressing status again displays the Fast Rinse Time. A
"3" will remain in the display and a "B" will appear on
the right side of the display. This setting can be
adjusted from 5-30 minutes.
5. Pressing status again will show the Salt Dosage. This
can be adjusted from 3-15 lbs. for the 9" and 5-24 lbs.
on 12" models. A number "4" will appear at the
bottom of the display while in this mode.
6. Press status again, this displays the Backwash Time.
The setting can be adjusted between 5 and 40 minutes.
A number "5" will appear at the bottom of the display
while in this mode.
Press to increase or
to decrease
Press to increase or
to decrease
Press to increase or
to decrease
Press to increase or
to decrease
Press to increase or
to decrease
9