Panasonic Viera X50D series Operating Instructions Manual page 16

Select the connection type
5
Connection Type
Please select network connection type.
WPS(Push button)
Search for access point
[WPS(Push button)]
1. Press the WPS button on the access point until the light flashes
2. Connect the Wireless LAN Adaptor with the access point
WPS(Push button)
1) Please press the 'WPS' button on the access
1) Please press the 'WPS' button on the access
point until its light flashes.
point until its light flashes.
2) When the light is flashing select 'Connect' on TV. 2) When the light is flashing select 'Connect' on
TV.
If you are unsure, please check the instruction
If you are unsure, please check the instruction
manual of the access point. manual of the access point.
Connect
3. After the access point setting is finished, perform the connection test
Connection Test
4. Go to the next step
(Press twice)
[Search for access point]
Access points found automatically are listed.
1. Select your desired access point
Available Access Points
No. SSID Wireless type
1 Access Point A 11n(2.4GHz)
2 Access Point B 11n(5GHz)
3 Access Point C 11n(5GHz)
2. Access the encryption key input mode
Encryption Key Setting
Connection will be made with the following settings:-
SSID : Access Point A
Authentication type : WPA-PSK
Encryption type : TKIP
Please input the encryption key.
Encryption key
3. Enter the encryption key of the access point
Access Point Settings
Encryption key
A B C D E F G H I J K L M N O P Q R S T
U V W X Y Z 0 1 2
a b c d e f g h i j
u v w x y z ( ) + -
● Ensure that your access point supports WPS for this setup.
●
WPS: Wi-Fi Protected Setup™
●
If the connection has failed, check the settings and positions of
your access point. And then, follow the on-screen instructions.
Check access point connection.
Check acquired IP address.
Check for devices using same IP address.
Check gateway connection.
Check server connection.
Encrypt Reception
: Encrypted access point
●
If the selected access point is not encrypted, the confirmation
screen will be displayed. It is recommended to select the encrypted
access point.
Set characters
3 4 5 6 7 8 9 ! : #
k l m n o p q r s t
. * _
●
You can set characters
by using numeric buttons.
(English only)
●
select If your access point supports WPS
(Push button), then select this
option. If not, select [Search for
access
access point].
: succeeded
The test is successful and the TV is
connected to the network.
: failed
Check the settings and connections.
● To search access points again
select
access
●
For the information of the
highlighted access point
INFO
select
set
(p. 69)
Y
Store
RETURN
15