Figure 31: Restarting The Amc-4W With The Provided Screw Driver; Figure 32: Resetting The Amc-4W To Delivery State - Bosch AMC-4W Installation Manual

Access Controller AMC-4W
Resetting the network configurations (figure32):
1. Reset the AMC as described above (in download program)
2. Open the upper case of the AMC-4W
3. Set all six DIL switches of the RS485 selector to ON
4. Press the tamper switch on the upper left side of the board
5. The AMC-4W will now have the following network configuration:
a.
b. IP = 127.0.0.1

Figure 31: Restarting the AMC-4W with the provided screw driver

Figure 32: Resetting the AMC-4W to delivery state

Bosch Security Systems | V.3.1/2006-09
DHCP = 0
Operating the AMC-4W
Installation Guide 43