Table of Contents
Advertisement
Headset base installation and battery charging
After installing the battery, charge the headset by placing it in
the magnetic charging mount as shown below. The
on when the headset is charging.
1.
Plug the small end of the headset base power adapter into
the POWER jack (green dot) at the back of the headset base.
Plug the large end into an electrical outlet not controlled by a
wall switch.
2.
Insert the headset into the
magnetic charging mount.
Magnetic
charging
mount
IMPORTANT INFORMATION
Use only the supplied rechargeable battery pack or replacement
battery pack (model BT19166). To order, visit our website at
www.telephones.att.com/smb
1 (800) 222-3111
.
. In Canada, dial
6
The magnet holds the top
of the headset in place.
The
light turns on.
or call
1 (866) 288-4268
light turns
.
Advertisement
Table of Contents
