Alarm Removal - Kidde KN-COSM-IBACA (900-0119) User Manual

Alarm Removal

IF TAMPER RESIST FEATURE HAS BEEN ACTIVATED, REFER
TO TAMPER RESIST FEATURE DESCRIPTION ABOVE FOR
REMOVAL INSTRUCTIONS.
Remove the alarm from the mounting bracket by rotating the
alarm in the direction of the "OFF" arrow on the cover.
If any form of battery failure is detected the red LED light will
flash and the unit will "chirp" one time, followed by the warning
message "LOW BATTERY". This cycle will occur once every
minute, and will continue for at least seven days. On battery
power, the "LOW BATTERY" voice occurs once every 15 minutes.
If the red LED light flashes along with a chirp every 30
seconds, and is not followed by the voice message "LOW
BATTERY" as described above, and if the green LED flashes
twice per second (AC power only) your unit has
malfunctioned. Call our toll free Product Support Line at
1-800-880-6788 for instructions on how to return the unit.
BATTERY INSTALLATION AND REMOVAL
To replace or install the batteries slide the battery door in the
direction indicated on the cover of the alarm.
When installing new batteries into the carrier, make sure that
the polarity matches the markings printed on the inside of the
battery compartment, press the battery reminder finger down
into the battery compartment and install the battery (see Figure
6). Completely slide the battery door to the closed position. A
missing or improperly installed battery will prevent the battery
door from closing and result in improper alarm operation.
SLIDE OPEN INSERT
FIGURE 5
20