Alarm Removal - Kidde P12040CA User Manual

3. Operation
Testing
NOTE: WEEKLY TESTING IS REQUIRED!
CAUTION: Due to the loudness (85 decibels) of the alarm, always stand an
arms length away from the unit when testing.
Test by pushing the test button on the cover and hold it down for a
minimum of 5 seconds. This will sound the alarm if all the electronics,
circuitry, horn and battery (if applicable) are working. If the alarm does
not sound insure that the AC power is on (green LED is illuminated).
If the AC power is on and you have already replaced the battery (if
applicable), the alarm must be replaced. DO NOT use an open flame
to test your alarm, you could damage the alarm or ignite combustible
materials and start a fire.
Test the alarm weekly to ensure proper operation. Erratic or low sound
coming from your alarm may indicate a defective alarm, and it should be
returned for service (see Warranty section).
Alarms failing an alarm test, or not operating normally, must be replaced
with a new alarm. Similarly, alarms more than 10 years old must be
replaced.

Alarm Removal

If the smoke alarm tamper resist feature has been activated, refer to the
Alarm Tamper Resist Feature section for removal instructions.
To remove the alarm from the mounting plate, rotate the alarm in the
direction of the "OFF" arrow on the cover. To disconnect the AC Quick-
Connect wire harness, squeeze the locking arms on the sides of the
Quick Connector while pulling the connector away from the bottom of
the alarm (see Image 5).