Table of Contents
Advertisement
Chapter Two: Hardware
This chapter is a general description of the device interfaces and connections. It describes the methods of
hard disk installation, the interface of the front panel and the rear panel for users to connect the cables
correctly.
1 Package Content
After purchasing the DVR product, unpack it and unload it flat onto the floor or a place where it is to be
located, and refer to the "Package Contents" for the correct number of device fittings.
2 Front Panel Operation
Type
Name
Power
LED
HDD
3 Rear Panel of Operation
NO.
Interface
1
Video In
2
TV Out
3
Audio Out
4
Audio In
5
VGA Output
Network Interface 1: RJ45 10/100M self-adaptive
6
USB Interface
7
RS485
8
Power
4 Remote Controller
NO.
Name
1
REC
2
Power ON/OFF
3
Numbers
4
Function Buttons
5
Arrow Buttons
6
Table 1 – Front Panel Description
Description
Red when recording. Green when not recording.
Hard disk indicator. Green or blinking when reading/writing.
Black when idle.
Table 2 – Rear Panel Description
Description
4/8 channel video input: BNC (1Vp_p, 75Ω)
1 channel TV output, BNC (1Vp-p, 75Ω
1 channel audio output, BNC (2Vp-p, 600Ω)
4 channels audio input: RCA (2Vp-p, 600Ω)
1: DIN-15
2: USB 2.0
1: Half Duplex ( + - )
DC 12V
Table 3 – Remote Controller Description
Description
Record
Turn the device off or on.
Input numbers or select to switch among relevant channels.
DEL: Delete
When in menu mode, press [
Press [▲ ], [▼ ] to select sub-menu parameters.
1) Press to confirm operations in menu mode.
2) Press to select record type in setting schedule.
3) Press to change status of the current motion detection block.
3
)
◄
], [► ] to move to selection boxes.
Advertisement
Table of Contents
