Takeuchi TB125 Operator's Manual page 231

OPTIONS
Radio (for EU)
To cancel the beep tones ............. 1, 7, 8
The unit emits a beep tone to confirm that a
function button has been pressed. To cancel
the function, follow the procedures below.
1 Turn off the power by depressing the ON/
OFF button 1.
2 With ACC on, press the ATP button 7
and the preset button 6 8 simultaneously
until the display lights. The beep tones are
boF
cancelled and
3 To turn the beep tones on again, repeat
steps 1 and 2 and
Tape operation
4
1
P SCAN .
4
B A N D
Selecting tape mode
Insert a cassette into the tape slot 1 and
the tape player will start.
Switching the tape direction ............ 2, 3
Press BUTTONS 2 and 3 simultaneously.
¡ When the tape reaches the end of one
side, the unit will automatically switch to
the opposite side of the tape.
Fast forward and rewind ................... 2, 3
Press button 2 to fast-forward; press button
3 to rewind the tape. To stop fast forwarding
or rewinding, lightly press the opposite button
2 or 3 to return to the play mode.
During fast forward and rewind, the radio
monitor is activated. The unit receives the
station selected last.
is displayed.
F
b-on
is displayed.
1 6 3 2
DIR
ATP
2 3
TUNE/SEEK
CLOCK
5 6
5
C4C031
Ejecting the tape ................................... 4
Press the EJECT button 4 to eject a tape.
The system will return to the audio source
selected last.
Radio operation
P SCAN .
B A N D
1
Selecting radio mode
Each time the BAND button is pressed, the
selected band changes as shown below.
→ FM1 → FM2 → MW
Radio tuning .......................................... 2
¡ Automatic tuning
Press the TUNE/SEEK + or - button 2
for more than 2 seconds.
When the button is released, the system
will start automatic tuning and stop at the
next receivable station.
¡Manual tuning
To select higher frequency stations, press
the + button for less than 0.5 seconds.
To select lower frequency stations, press
the - button for less than 0.5 seconds.
To quickly scan up or down in frequency,
press and hold the + or - button.
Release the button when the display
approaches the desired frequency, then
press and release the button repeatedly
until the desired frequency is displayed.
A flashing decimal point in the frequency
display indicates that the system is
receiving a station 50 kHz higher than the
displayed frequency.
229
3 4
DIR
ATP
1 2 3
TUNE/SEEK
CLOCK
4 5 6
2
C4C032