Replacing The Engine Oil And Oil Filter - Takeuchi TB125 Operator's Manual

MAINTENANCE
After First 50 Hours (New Machines Only)
Replacing the Engine Oil and
Oil Filter
WARNING
Stop the engine and allow the machine
to cool down before performing
maintenance.
¡ ¡ ¡ ¡ ¡ The engine, muffler, radiator and many
other parts of the machine are hot
directly after the engine is stopped.
Touching these parts will cause burns.
¡ ¡ ¡ ¡ ¡ The engine oil is also hot.
Be careful when loosening caps and
plugs. Working on the machine under
these conditions could result in burns.
B
A
1. Place a pan for catching the spent oil
under the drain plug (3).
2. Remove cap (A), install connector (B) and
drain the oil. (The oil comes out when the
screw is tightened.)
3. Remove connector (B) and install cap (A).
IMPORTANT: Check the spent oil. If it
contains large amounts of metal powder,
consult a Takeuchi sales or service outlet.
L
4. Open the engine hood.
5. Using a filter wrench, turn the filter (4)
counterclockwise and remove it.
6. Clean the filter installation surface on the
filter stand.
7. Apply a thin layer of oil to the packing of
the new filter.
8. Install the new filter by hand.
9. Tighten 3/4 more turn with the filter wrench
after the filter packing comes in contact
with the surface of installation.
10. Remove the oil supply cap (2).
11. Supply oil up to the upper limit (H) of the
dipstick (1). Problems could arise if the
oil level is either too low or too high.
3
12. Tighten the oil supply cap (2).
13. Start the engine, run it at low idle for about
G4G012
3 minutes, then stop it.
14. After about 10 minutes, inspect the oil
level.
109
1
H
2
4
L4G019