Operation; File Setting - JVC KY-F58 Instruction

5. OPERATION

FILE SETTING

There are four scene files to be set by dip switch depending on the operating conditions.
Scene File A including four sub files are all set to the standard shipment setting values. Change the settings according to the requirements.
Scene File B, C and D should be set to required file settings before use such as Slit inspection, Microscope
Note:
Before carry out operations below, make sure the LOCK switch is turned OFF.
DIP switch
LOCK MENU ITEM+ DATA+
ON
BARS
SET ITEM- DATA-
RESET
1 2 3 4
OFF
TO CAMERA WHITE PAINT
SET
R B
PAINT
Changing setting
values
LOCK MENU ITEM+ DATA+
ON
BARS
SET ITEM- DATA-
RESET
1 2 3 4
OFF
TO CAMERA WHITE PAINT
SET
R B
PAINT
SELECT button
CAMERA CONTROL UNIT KY-F58
FILES FREEZE
1 2 3 4
SELECT MEMORY
POWER
VIDEO LEVEL
FULL AUTO LEVEL
ON
OFF
MEMORY button
CAMERA CONTROL UNIT KY-F58
FILES FREEZE
1 2 3 4
SELECT MEMORY
POWER
VIDEO LEVEL
FULL AUTO LEVEL
ON
OFF
Scene File Setting
Select the "Scene File" with the dip switch 1 and 2 according
to the purposes.
Scene File Dip switch setting
1. OFF
1 2 3 4
2. OFF
A
3, 4. Do not switch over
1. ON
1 2 3 4
B 2. OFF
3, 4. Do not switch over
1. OFF
1 2 3 4
C 2. ON
3, 4. Do not switch over
1. ON
1 2 3 4
D 2. ON
3, 4. Do not switch over
Note:
Switch off the power when switching the Scene File over. If
it is carried out while the power is ON, it will not be changed.
FILE Setting
Each Scene File has four of sub files (FILE) to be set.
Each time the SELECT button is pressed, it is switched in the
order of
FILE1 FILE2 FILE3
It takes 1 second to switch over the FILE. LED blinks rapidly
during the FILE switching operation.
Note:
Do not perform other operations during the LED blinking, it
may cause the KY-F58 to malfunction.
The FILE setting is completed when the LED stops blinking, and
lights.
Changing setting values
The setting value is changed for each file.
Refer to the "6. SETTINGS ON THE MENU SCREEN" on
page 18.
Registration to the FILE
Setting values can be registered to each FILE.
Press the MEMORY button for 2 sec. or more for registration.
The setting value is registered to the FILE which LED lights. It
takes approx. 2 sec. for registration. During the registration,
the LED blinks slowly.
The FILE registration is completed when the LED stops blink-
ing, and lights.
Note:
• To register a value which has been changed on the MENU
screen or with a volume level knob, make sure to register
any changes in the selected file. If the power is turned off
without registering the changes, they will be automatically
erased.
• Do not perform other operations during the LED blinking, it
may cause the KY-F58 to malfunction.
, Microscope , etc.
1 2
Example for use
Standard
setting
Slit
Inspection
Microscope
Microscope
FILE4
.
1
2
15