System Application - JVC KY-F58 Instruction

SYSTEM APPLICATION

(Front panel)
AC- INPUT SEE INSTRUCTION MANUAL
LENS
REMOTE
LENS
To 120V AC
REMOTE
Lens remote control
To start a flash light with a foot switch
• Connect an external trigger such as a foot switch to the
FREEZE connector.
• Connect a flash light to the FLASH connector.
• Set the FREEZE MENU to "FLASH".
To output an image from the KY-F58 under the tim-
ing of the image processing unit
• Connect an external sync signal of the image processing
unit to the VD and HD/VBS connector of this unit.
• Connect the image output connector to the image input
connector of the image processing unit.
To output an image to the image processing unit
under the timing of the KY-F58
• Connect the WEN (Write Enable) connector of the KY-F58
to the image processing unit.
• Connect the image output connector to the image input
connector of the image processing unit.
VD
HD/VBS
RS-232C EXT REF OUTPUT
VD HD/VBS
VIDEO
EXT TRIGGER
FLASH WEN FREEZE RGB/COMPONENT
FLASH WEN FREEZE VIDEO
Foot switch, etc.
Y/C
VD
HD/VBS
RGB
WEN
VIDEO IN
Monitor
Note:
Before starting the connection, please thoroughly read the
Technical Information on page 26 and following.
3. CONNECTIONS (Cont'd)
Camera head
Microscope adapter
HZ-M161/M162/M163
Flash light
Image processing unit
Microscope
11