Toshiba MMD-AP0074SPH-E Installation Manual page 12

SMMS Slim Duct Type
Mount an air filter to the air intake side; otherwise decrease of capacity may be caused.
<Under air intake>
Take out this cover plate.
21-EN
Installation Manual
<Back air intake>
Main unit
Air filter
Push
Remove the filter from the
main unit while pushing
down on the tabs.
Remove the cover plate and then fix
it to the bottom surface.
SMMS Slim Duct Type
– 11 –
Connecting method of the duct
Heat insulator with sticking material (100 mm - width locally procured)
Aluminum tape (locally procured)
Flange
Duct: Insulation
materia
(locally procured)
Air discharge side
Aluminum tape
(locally procured)
Heat insulator with sticking material (100 mm-width locally procured)
CAUTION
Incomplete heat insulation of the supply air flange and sealing may occur dewing resulted in falling of water drop.
Installation Manual
Flange (locally procured)
Connect a duct to the
inside of the flange
Aluminum tape (locally procured)
Indoor unit
Air intake side
Aluminum tape (locally procured)
Cover a screw Under surface
22-EN