Table of Contents
Advertisement
Frost™, available through Dow Chemical®
distributors.
NOTE: Prior to refilling the PowerPool™,
drain all antifreeze from PowerPool™ and
hoses using the instructions for Draining
Your PowerPool™ (Pg. 26). Carefully
monitor chemicals until all antifreeze
residue has been eliminated.
3. The filter should be drained, and the
cartridge removed and cleaned.
4. Check to see that there is no water in the
heater element chamber.
5. Clean your PowerPool™ as directed in the
following two sections on this page.
6. Cover your PowerPool™ with a water-
shedding, impenetrable cover.
7. For further information on blowing out
the plumbing lines and winterising
procedures, contact your local dealer.
PowerPool™ Cabinet Care
The PowerPool™ series cabinets are made of
Duramaax™, a high quality alternative to wood
that is virtually maintenance free, requiring
no staining, sealing, or waxing.
Never use abrasive cleaners.
To clean the PowerPool™ cabinet, rinse dirt
and dust regularly with clear water. To remove
stubborn dirt, grime, and mild discoloration,
wash with a mild detergent and warm water.
PowerPool™ Surface Care and Cleaning
Your PowerPool™ shell surface is made of
acrylic. A minimum amount of care and
cleaning will keep it looking new for years.
Use a spa cleaner for residue and lime buildup
at the water level. It may be necessary to lower
the water level 0.5 to 0.75 cm before cleaning
28
PowerPool™
to avoid polluting the PowerPool™. Cleaner
can be applied to the acrylic surface with a soft
cloth and wiped clean. Use a non-abrasive mild
dish washing detergent such as Ivory®Liquid.
Rinse well and dry with a clean cloth.
NOTE: Do not allow the acrylic surface to
come in contact with products such as
acetone (nail polish remover), nail polish,
dry cleaning solution, lacquer thinners,
gasoline, pine oil, orange oil, citrus based
cleaners, etc.
Remove dust and dry dirt with a soft, damp
cloth. Clean grease, oil, paint and ink stains
with isopropyl (rubbing) alcohol diluted with
water. Avoid using razor blades or other sharp
instruments that might scratch the surface.
Protect PowerPool™ finish - always keep
cover on the PowerPool™ when not in use.
Underwater LED Light Cluster
The underwater LED light assemblies are
serviceable from the inside the PowerPool™
cabinet. Remove the side panel and insulation
closest to the light; locate the bracket that
holds the LED assembly. Turn the LED Holder
90 degrees counter-clockwise; remove from
bracket. Pull bulb straight out and replace.
Insert LED holder back into bracket and turn
90 degrees clock-wise to secure.
28
Hide quick links:
Advertisement
Table of Contents
