User's Pads; Temperature Controls - MAAX Spas Powerpool Owner's Manual

User's Pads

User's Pads are the buttons located on the
topside control panel and are used to program
various PowerPool™ functions (i.e., turn on
PowerPool™ light, set temperature, etc.). The
following table defines the pads:
Pad
• Increase temperature
• Change time settings
• Decrease temperature
• Change time settings
• Turn internal PowerPool™ light
on or off
• Set or lock/unlock temperatures
• Set or lock/unlock panel settings
• Switch modes
• Set time and filtration cycles
• Activate primary filtration pump
• Activate therapy pump
• Change time of day setting, or
• Change set times of
PowerPool™ cycles
• Exit programming
• Activate therapy pump
17
PowerPool™
Use
Temperature
The maximum set temperature is 104°F (40°C)
and the minimum set temperature is 80°F
(26°C). The current water temperature will show
on the display unless the primary pump has
not been running, in which case two dashes
(--) will show on the display. If two dashes are
displayed, you must first start the pump by
pressing the JETS 1 pad. Wait until the water
temperature is displayed (approximately 2
minutes).
The set temperature of your PowerPool™ may
easily be increased or decreased at any time
using the WARM or COOL pads. When either
of these pads is touched, the set temperature
will be displayed in the LCD display window.
Each successive touch will change the set
temperature 1°F (0.5°C) in the chosen direction.
After 3 seconds the LCD will automatically
display the water temperature or dash lines.
If the PowerPool™ is set in Standard mode or in
a filtration cycle, adjusting the set temperature
may result in activating the heater. When
the heater is operating, the heat icon will be
displayed in the LCD.
JETS 1
Touch the JETS 1 pad to activate the primary
filtration and jet pump. The sequence of the
jet action is: 1 touch
2 touches = High jets
3 touches = Off
JETS 2 & JETS 3
Touch the JETS 2 pad to activate the number 2
Jet pump and Touch the JETS 3 pad to activate
the number 3 Jet pump. The sequence of jet
action is: 1 touch
2 touches = High jets
3 touches = Off
= Low jets
= Low jets
17