Temperature Lock; Temperature Unlock; Panel Lock; Panel Unlock - MAAX Spas Powerpool Owner's Manual

The low speed operation of Pump 1 is timed
to automatically turn off after four hours of
operation.
The high speed operation of Pump 1, and the
low and high speed operation of Pump 2 and
Pump 3, is timed to automatically turn off after
15 minutes of operation.
Note: Pump 1 will automatically operate in
low speed whenever the PowerPool™ calls
for a filtration cycle or heat.
When this automatic activation occurs, the
low speed of Pump 1 cannot be turned off;
however, all other control functions can be
activated.

Temperature Lock

Once you have set the desired water
temperature, you may lock-in the new
setting to prevent unauthorized temperature
adjustments to your PowerPool™. To lock the
set temperature:
Touch WARM or COOL, then touch TIME,
JETS 1, and WARM within 3 seconds. The 'TL'
indicator will light when the set temperature
is locked.

Temperature Unlock

To unlock the temperature, touch either
WARM or COOL, then touch TIME, JETS 1, and
COOL within 3 seconds. The 'TL' indicator light
will go out when the set temperature lock is
cleared.

Panel Lock

To help prevent unauthorized use of your
PowerPool™, the control system has a unique
panel locking system. To lock the panel, touch
TIME, JETS 1, then WARM within 3 seconds.
18
PowerPool™
When locked, the 'PL' indicator light will be
on. Except for the time button, all function
settings will be frozen.
When the control panel lock is engaged, all
automatic PowerPool™ functions will operate
normally but cannot be altered.

Panel Unlock

To unlock the panel, touch the TIME, JETS 1,
and COOL within 3 seconds. The 'PL' indicator
light will go out when the panel lock is
cleared.
Light
Touch the LIGHT pad to turn the digital
lighting system on and off. The light will
automatically turn off after 60 minutes of
operation.

Operating Modes

Your PowerPool™ comes with three
primary operating modes.
Standard Mode maintains the water at
the desired set temperature. Note that the
last measured PowerPool™ temperature
displayed is current only when the pump
has been running for at least 2 minutes. The
'STANDARD' icon will be displayed in the LCD
window when this mode is selected.
Economy Mode heats the water to the
desired set temperature ONLY during
filter cycles. The 'ECONOMY' icon will be
displayed in the LCD window when this
mode is selected. While in the Economy
mode, pressing the JETS 1 button will put
the PowerPool™ into the Standard-In-
Economy mode, which operates the same as
the Standard Mode, then reverts back to the
Economy mode after 1 hour. The PowerPool™
18