Jets And Air Controls; Jets; Cleaning Or Replacing Jets - MAAX Spas Powerpool Owner's Manual

JETS AND AIR CONTROLS

Swim Area Jets
PowerPool™ MAAX®-Force jets are designed
to produce a smooth flow of water with high
output to create a consistent swim stream.
Whether you want to swim or walk/jog against
the force of the jets, you will find the flow of
water deep enough and swift enough to meet
your individual needs.
Hydrotherapy Area Jets
All of the hydrotherapy jets are individually
engineered to provide a unique hydro-massage.
Depending on the model, your PowerPool™
will have a combination of the following jets:
Cyclone Therapeutic
(XL Cyclone, LS Cyclone, & Cyclone):
Positioned to focus on large muscle groups,
these jets deliver a concentrated, high volume
stream of water for a deep massage. Each jet
is fully adjustable, allowing users to set the
water flow to the most comfortable setting.
The nozzle can be rotated to target sore
muscle areas.
Cyclone Turbo Swirl Jets
(XL Cyclone, LS Cyclone, & Cyclone):
Positioned to focus on muscle tension zones,
these jets deliver a spinning V-shaped water
stream for a gentle, pulsating massage. Each
jet is fully adjustable, allowing users to set
the water flow to the most comfortable setting.
Cluster Jets:
Positioned in the foot well or shoulder areas
of the PowerPool™, these jets deliver a
penetrating massage to dissolve tension. This
jet may be the entry point for ozone produced
during the automatic filtration cycles, and,
11
PowerPool™
as such, is not adjustable.
Note: Ozone production is suspended when
other functions are activated on the control
panel by the PowerPool™ user.
All full sized jets are adjustable from a fully
open to closed position. It is very important
that you NEVER SHUT ALL FULL SIZED JETS
OFF AT ONE TIME!

Cleaning or Replacing Jets

Hard water can cause calcium/mineral
buildup that can restrict or bind the jets. A jet
consists of a face plate and a nozzle. Rotate
these parts weekly and remove/clean monthly
to ensure free movement.
NOTE: It is not necessary to drain the pool
or spa to clean or remove the jets.
Rotating the jet face plate and nozzle
• Rotate the jet face left and right
(open and closed).
• Return the face plate to the full open
position.
• Turn the jets on to high speed.
• Twist the nozzle left and right.
• Rotate the nozzle in the socket.
NOTE: If the jet insert disengages from the
PowerPool™ housing, see steps to reinstall
below.
Cleaning the jets
To remove the jet insert, use the palm of your
hand to exert pressure on the face of the jet.
Turn counterclockwise until the jet 'clicks' .
Gently pull the jet assembly from the housing.
11