Dmx Mode; Master / Slave Addressing; Sound Control Mode - SHOWTEC LED Light Bar 8 Product Manual

1. DMX Mode

With this menu you can set the DMX address.
1) Press the MODE button, until the display shows
2) You can choose 512 different DMX addresses.
Use the Up / Down buttons to select the required address from
3) You can also press the SETUP button to set a different DMX Mode
3 Channels
4 Channels
14 Channels
26 Channels
2 Channels
7 Channels

2. Master / slave addressing

Master
1) The default setting for this device is master.
2) Only one fixture can be the master.
Note:
• Disconnect the fixture from the DMX controller before master/slave operating, otherwise data
collisions may occur and the fixtures will not work properly!
• In master/slave mode, the master fixture can execute the built-in programs, all the slave fixtures will
work the same.
• When operating the master/slave chain, you can identify the master fixture from the slave fixtures
easily. The master doesn't have any cable plugged into the DMX input connector.
Slave control
This function allows you to control the slaves from the master's control panel in a master/slave operation.
1) Only 1 fixture can be the master, the others have to be Slaves. The Default setting for a device is
Master. So on the first device you don't have to change anything.
On the slave devices you must press the MODE button until the display shows
2) All slave devices must have address

3. Sound control Mode

1) Press the MODE button on the device, until the display shows
LED Light Bar will react to the beat of the music.
You can set the sensitivity from low-sensitivity to high-sensitivity between SU.00 - SU.31.
.
.
13
.
.
. Turn on the music and the
.