Table of Contents
Advertisement
One LED Light Bar 8 (Sound-control)
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2. When the
LED Light Bar 8
Turn on the music. If device is set to
will react to the beat of the music.
programs.
Multiple
LED Light Bars (Master/Slave control)
1.
Fasten the effect light onto firm trussing.
2.
Plug the end of the electric mains power cord into a proper electric power supply socket.
3.
Use a 3-p XLR cable to connect the LED Light Bar.
The pins:
4.
Link the units as shown in (Fig. 3), Connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
use the same functions on the master device as described on page 13-16 (Built-in Programs, Auto
Run, Static Color or
operation Mode and all slave devices will react the same as the master device.
Multiple LED Light Bars (DMX Control)
1.
Fasten the effect light onto firm trussing.
2.
Plug the end of the electric mains power cord into a proper electric power supply socket.
3.
Use a 3-p XLR cable to connect the LED Light Bar and other devices.
is not connected by a DMX-cable, it functions as a stand-alone device.
Please see page 13 for more information about the built-in
1.
Earth
2.
Signal -
3.
Signal +
Music control). This means on the master device you can set your desired
Multiple LED Light Bars
(Audio) and you have pressed enter, then the fixture
Leave at least 1 meter on all sides for air circulation.
(Master/Slave control)
Leave at least 1 meter on all sides for air circulation.
8
You can
Fig. 3
Hide quick links:
Advertisement
Table of Contents
