Running your train
Expanding the Maxi-Stack into a unit train
I
f you wish to articulate your Maxi-Stack with additional sets, you will need to add on to the ends of
each set. Refer to Figure 9 on page 14 to help identify the parts.
Do not over-tighten the screws or damage could be caused to the cars and connectors.
Caution!
1. Remove the truck from the non-brakewheel end of the Maxi-Stack Set using a 3/16" nut driver to
remove the hex-head screw (labeled "B" in Figure 9) from the bottom of the truck.
2. Remove the Phillips head screw (labeled "C" in Figure 9) from the bottom of the platform.
Female articu-
lating
connector
Figure 7. Platform removal and connector attachment
Platform
12
12