PMU2300III Series Service Manual
1-2-8. Disassembling "UNIT, Paper Holder (PHU-203T)"
1.
Removing "Plate, Paper Holder 203 R" and "Plate, Paper Holder 203 L"
1. Remove two "Screw, PHT (ST), M3 × 6" that fasten "Plate, Paper Holder 203 R" and "Plate,
Paper Holder 203 L", respectively, and remove them from "FRAME IF BOARD".
Plate Paper Holder 203 R
2.
Removing "PNE, SENSOR"
1. Remove "SCREW, PHT M3 × 3 (ST)" and "WASHER, PLAIN, 3 × 8 × 0.5" from "PLATE, PAPER
HOLDER 203 R". Remove "SA, PNE SENSOR" from "Cord Holder".
•
SCREW, PHT M3 × 3 (ST)
•
WASHER, PLANE, 3 × 8 × 0.5
3.
Removing "TENSION, LEVER"
1. Remove two "SCREW, PHT M3 × 3 (ST)" that fasten "COVER, LEVER".
Screw, PHT (ST), M3 × 6
Cord Holder
COVER, LEVER
Plate Paper Holder 203 L
Screw, PHT (ST), M3 × 6
Disconnect the connector
from CN108.
When reassembling, align the
bosses with these holes.
- 22 -