PMU2300III Series Service Manual
3. Remove two "Screw, PHT (ST), M3 × 6" and remove "PLATE PRINTER" from "UNIT,
MECHANISM".
When reassembling, insert the lugs
at "PLATE PRINTER" into the
notches at "UNIT, MECHANISM".
3.
Removing "AUTO CUTTER"
1. Remove two "SCREW, No. 00, TFH (ST), M3 × 6 (Thin head)" from both sides.
2. Remove "AUTO CUTTER" while pulling "CUTTER BK" outwardly.
* Be careful not to deform "Cutter BK" by pulling it excessively outward.
SCREW, No.00, TFH (ST), M3 × 6 (Thin head)
*
When reassembling,
hang the cable to the
hook.
AUTO CUTTER
CUTTER BK
- 18 -
Screw, PHT (ST), M3 × 6
PLATE PRINTER
Hook
Hook
When reassembling,
align the bosses with
the grooves.