Message Codes; Care; Warranty; Safety Instructions - Leica Disto X310 Instructions Manual

Message Codes

If the message Error does not disappear
after switching on the device repeatedly,
contact the dealer.
If the message InFo appears with a number,
press the Clear button and observe the
following instructions:
No. Cause Correction
156 Transverse tilt greater Hold the instrument
than 10° without any transverse tilt.
162 Calibration mistake Make sure, the device is
placed on a absolutely
horizontal and flat surface.
Repeat the calibration
procedure. If the mistake
still occurs, contact your
dealer.
204 Calculation error Perform measurement
again.
252 Temperature too high Let device cool down.
253 Temperature too low Warm device up.
255 Received signal too Change target surface
weak, measuring time (e.g. white paper).
too long
256 Received signal too Change target surface
high (e.g. white paper).
257 Too much back- Shadow target area.
ground light
258 Measurement outside Correct range.
of measuring range
260 Laser beam inter- Repeat measurement.
rupted
TM
Leica DISTO X310 788479a

Care

• Clean the device with a damp, soft cloth.
• Never immerse the device in water.
• Never use aggressive cleaning agents or
solvents.

Warranty

The device comes with a 3-year warranty. To
receive the 3-year warranty, the product
must be registered on www.disto.com
within 8 weeks of the purchase date. If the
product is not registered, a 2-year warranty
applies.

Safety Instructions

The person responsible for the instrument
must ensure that all users understand these
directions and adhere to them.

Areas of responsibility

Responsibilities of the manufacturer
of the original equipment:
Leica Geosystems AG
Heinrich-Wild-Strasse
CH-9435 Heerbrugg
Internet: www.disto.com
The company above is responsible for
supplying the product, including the User
Manual in a completely safe condition.
The company above is not responsible for
third party accessories.
Responsibilities of the person in
charge of the instrument:
• To understand the safety instructions on
the product and the instructions in the
User Manual.
• To be familiar with local safety regulations
relating to accident prevention.
• Always prevent access to the product by
unauthorised personnel.
EN
18