Bulbs - MOTO GUZZI Griso Use And Maintenance Book

1
u Place the vehicle upright.
u Turn screw (2) to set headlight beam.
When finished:
WARNING
Make sure that the vertical adjustment
of the headlight beam is corr ect.
Different jurisdictions have different
requirements for horizontal headlight
beaming. Make sure that you comply
with the rules of the jurisdiction where
your vehicle is being used.
96 use and maintenance Griso
2

BULBS

C a r e f u l l y r e a d
(MAINTENANCE).
WARNING
Do not use the vehicle if the lights are
not functioning properly.
Do not use the vehicle if the headlight is
a d j u s t e d i n c o r r e c t l y . T h i s c o u l d
temporarily blind oncoming cars, and
also reduce the rider's ability to see any
obstacle along the road while riding at
night.
It is always advisable to reduce speed
when riding at night, so as to have the
time necessary to avoid any obstacle
and to adapt to the poorer visibility that
inevitably results from darkness.
Failure to observe this warning can
cause you to collide with another
object, with consequent risk of serious
injury or even death.
p a g e 7 1
Fire hazard.
K e e p f u e l a n d o t h e r f l a m m a b l e
s u b s t a n c e s a w a y f r o m e l e c t r i c
components.
Before proceeding to change a bulb, set
the ignition switch to "
some time for the bulb to cool down.
Wear clean gloves or use a clean, dry
cloth to handle the new bulb. Do not put
your fingerprints on the bulb, as this
may lead to overheating and failure.
If you have handled the bulb with bare
hands, clean it with alcohol to avoid any
damage.
DO NOT PULL ON THE WIRES.
NOTE
Before changing a bulb, check
the fuses, see page 93 (CHANGING THE
FUSES).
WARNING
CAUTION
" and allow