EPOX EP-61LXA-M Manual page 46

EP-61LXA-M
Onboard IR Controller: IrDA Controller.
The default is Enabled.
IR Address Select: The port location of the IR controller.
The default is 2E8H.
IR Mode: The mode of the IR controller.
The default is IrDA
IR Transaction Delay:
The default is Enabled.
IR IRQ Select:
The default is IRQ 10
IR Mode use DMA:
The default is Disable.
Onboard Parallel port: This field allows the user to configure the LPT port.
The default is 378H / IRQ7.
378H: Enable Onboard LPT port and address is 378H and IRQ7.
278H: Enable Onboard LPT port and address is 278H and IRQ5.
3BCH: Enable Onboard LPT port and address is 3BCH and IRQ7.
Disabled: Disable Onboard Winbond Chip's LPT port.
Parallel Port Mode: This field allows the user to select the parallel port mode.
The default is ECP+EPP.
Normal: Standard mode. IBM PC/AT Compatible bidirectional parallel port.
EPP: Enhanced Parallel Port mode.
ECP: Extended Capabilities Port mode.
EPP+ECP: ECP Mode & EPP Mode.
ECP Mode USE DMA: This field allows the user to select DMA1 or DMA3 for
the ECP mode.
The default is DMA3.
DMA1: This field selects the routing of DMA1 for the ECP mode.
DMA3: This field selects the routing of DMA3 for the ECP mode.
BIOS
Page 4-23