Yamaha RTX810 Instruction Manual page 160

Initializing the product settings
6
When the system goes into a pending status
for selecting a setting file, select a setting file
that is not shown, from 0 to 4.2, and press the
Enter key.
8
If the firmware is started, the firmware version and
other information is displayed.
7
Wait for around 10 seconds, and press the
Enter key.
8
When "Password:" appears, press the Enter
key.
When ">" is displayed, you can enter a console
command.
Tip
If the login password has been set, enter the login password.
9
Type in "administrator", and press the Enter
key.
10
When "Password:" appears, press the Enter
key.
Tip
If an administration password has been set, enter the
administration password.
11
When "#" appears, enter "cold start" and press
the Enter key.
160
(Continued from the previous page)
12
When "Password:" appears, press the Enter
key.
Tip
If an administration password has been set, enter the
administration password.
The product settings are initialized.
Initializing through button operation of
the product
You can also restore the setting to their factory defaults
by turning the power on while pressing the three buttons;
DOWNLOAD, microSD, and USB buttons.
1
Turn the power on while pressing the three
buttons; DOWNLOAD, microSD, and USB
buttons.
DOWNLOAD button
microSD button
The lamp at the front side of the main unit lights up
and flashes several times.
2
Turn the power on, wait for 3 seconds, and
then press the three buttons; DOWNLOAD,
microSD, and USB buttons.
The product settings are initialized.
USB button