Switching on the appliance and setting the temperature
o Press the power button to switch the appliance on.
o If the appliance is being switched on for the first time, or after it
has been disconnected from the power supply, the LED display
will show the factory pre-set temperature of +12°C.
of these buttons will adjust the temperature on the LED display
by one degree.
o Whilst you are setting the temperature of the cooling zone, the
LED display will flash. When you stop pressing the temperature
buttons, after 3 seconds the display will stop flashing and the
temperature of the cooling zone will be set.
o The LED display will show the temperature that is currently being
registered by the cooling zone.
Changing between Fahrenheit and Celsius
o You can select whether the LED display shows Celsius
or Fahrenheit by pressing and holding the light control
button for about 5 seconds.
o The Celsius / Fahrenheit indicator neons will light to show
whether Celsius or Fahrenheit is currently shown.
o You cannot change the display if you are in the process of
adjusting the temperature of the cooling zone (i.e. the display is
flashing).
Interior light
o To operate the interior light, you should use the light
ON/OFF button.
o You cannot operate the interior light if you are in the process of
adjusting the temperature of a cooling zone (i.e. the displays are
flashing).
o Use the temperature increase and
temperature decrease buttons to set the
temperature that you require. Each press
12