Martin Exterior 1200 User Manual page 46

The following options are available:
Intensity
Cyan
Magenta
Yellow
Zoom
Focus
Color filter
Gobo
Animation
Scene fade
time
Scene wait
time
46
The dimmer provides smooth, high-resolution 0 - 100%
dimming.
The CMY color mixing system is based on graduated cyan,
magenta, and yellow color filters. A full spectrum of colors can
be achieved by varying the amount of each filter from 0 to
100%.
Note that mixing 3 colors results in loss of light - the light is
blacked out when all 3 colors are fully applied. For maximum
brightness, mix only 2 colors at a time.
The lens can be driven forwards or backwards to vary the size
of the beam.
Focus can be adjusted from approximately 2 meters to infinity.
Note that sharpest focus is achieved when projecting onto a
surface that is at 90° to the axis of projection. Soft focus gives
best results with some animation effects.
Click on one of the four square buttons colored blue, green, red
or white to select a filter in the color wheel.
Note that depending on which filters are installed and their
positions in the color wheel, the color applied may not be the
same as the color of the button in the MUM window.
Gobo 1 - 4 can be selected by clicking on the appropriate
numbered button. Speed and direction of rotation is set by
moving the Rotate slider.
The angle of the animated patterns in the gobo projection is set
by moving the User slider. The speed and direction of
movement of the patterns is set by moving the Rotate slider.
The fade time, anything from 0 to 120 seconds, is the time it
takes to change from one effect to another.
This is the duration a color is applied. A wait time can be from 1
second to 12 hours.
Exterior 1200 Image Projector user manual