Table of Contents
Advertisement
DMX address
If you intend to use a DMX controller, you need to set the luminaire's DMX address. If you
are not familiar with the principles of DMX addressing in an installation with multiple
fixtures, see "7.1.1: Setting DMX addresses" on page 52.
To set the DMX address:
1. Press the Menu button to enter the main menu and use the Up and Down buttons if
necessary to select F ix t u r e a d d re s s .
2. Press Enter.
3. Use Up and Down to enter a value between 1 and 496 (512 DMX channels are
available in one DMX universe, and the Exterior 1200 Image Projector uses 17
channels). Pressing Up and Down simultaneously sets the DMX address to 1.
4. Press Enter to confirm your choice and return to main menu. If you press Menu, you
will return to the main menu without saving the address you entered.
Clock
The Exterior 1200 Image Projector has a battery-operated 24-hour clock that is used to
start and stop stand-alone operation.
To set the clock:
1. If the display is showing Fi x t u re s t at u s , F an s t at u s and L am p st a t u s ,
press Menu to enter the main menu. Scroll down to P e r so n a li t y. and press Enter.
2. In the P e r s on a l i ty menu, scroll down to S et c lo c k .
3. Set the luminaire to the current time (expressed in the 24-hour clock in hours and
minutes) by entering values for Ho u r and Mi n u t e . Use the Up and Down buttons to
scroll values and Enter to confirm.
Luminaire settings
Luminaire settings are accessed in the Pe r s on a l i ty menu.
DMX La mp Off an d DMX R eset setting s
If DMX will be used to control the luminaire, it is a good idea to set the DMX Lamp Off and
DMX Reset options via P e r so n a l it y → D M X L a m p O f f and P er s o n al i t y → D MX
R e s et . These settings are described in "7.1: Preparing for DMX control" on page 52.
Automatic lamp on
When Pe r s o na l i t y → A u t o L a m p O n is set to O n (the default setting), the luminaire
turns on the lamp within 90 seconds of power on. Use this setting if you intend to run
stand-alone shows. When set to O f f, a lamp-on command from the DMX controller is
required to turn on the lamp.
38
Exterior 1200 Image Projector user manual
Advertisement
Table of Contents
