Enterasys RoamAbout RBT-4102 Installation Manual page 32

Hardware Installation
• Using the mounting bracket, mark the position of the four screw holes on the
wall or ceiling. For concrete or brick walls, you will need to drill holes and insert
wall plugs for the screws.
• Position the mounting bracket over the wall or ceiling screw holes, then insert
the included screws and tighten them down to secure the bracket firmly to the
wall or ceiling.
• Attach the access point to the mounting bracket. Line up the two mounting
points on the access point with the two mounting slots on the bracket (see the
following figure). Place the mounting points of the access point into the
mounting slots of the bracket, slide it into position so that the bracket fastening
screw on the access point lines up with the tab on the bracket. Then screw
down the fastening screw to secure the access point to the bracket.
Mounting
Points
Fastening
Screw
Align this tab with
the Fastening
Screw
2-2
Mounting
Slots