Automatic Demonstration - JVC GR-DVL567 Instructions Manual

Jvc digital video camera instructions

Hide thumbs

Table of Contents

How To Attach The Core Filter

Attach the Core Filter(s) (if provided with your model

reduces interference.

Stopper

Release the

stoppers on both

ends of the Core

Filter.

When connecting cables, attach the end with the Core Filter to the camcorder.

Automatic Demonstration takes place when "DEMO

MODE" is set to "ON" (factory-preset).

Automatic Demonstration starts when there is no operation for

about 3 minutes after the Power Switch is set to "

" and no cassette is in the camcorder.

Performing any operation during the demonstration stops the

demonstration temporarily. If no operation is performed for more

than 3 minutes after that, the demonstration will resume.

"DEMO MODE" remains "ON" even if the camcorder power is

turned off.

To cancel Automatic Demonstration:

1. Set the Power Switch to "

Lock Button located on the switch and press the MENU/

BRIGHT wheel in. The Menu Screen appears.

2. Rotate the MENU/BRIGHT wheel to select "

and press it. The SYSTEM Menu appears.

3. Rotate the MENU/BRIGHT wheel to select "DEMO MODE"

and press it. The Sub Menu appears.

4. Rotate the MENU/BRIGHT wheel to select "OFF" and press it.

5. Rotate the MENU/BRIGHT wheel to select "

and press it twice. The normal screen appears.

NOTE:

If you do not detach the Lens Cap, you cannot see the actual changes of the

Automatic Demonstration activated on the LCD monitor or viewfinder.

3 cm

Run the cable through the Core Filter, leaving approx.

3 cm of cable between the cable plug and the Core Filter.

Wind the cable once around the outside of the Core Filter

as shown in the illustration.

• Wind the cable so that it is not slack.

NOTE:

Take care not to damage the cable.