Panasonic KX-TDE100 Installation Manual page 153

5. Click Connect.
6. a.
Select KX-TDE100/200 from PBX Model.
b.
Select the LAN or RS-232C tab, depending on the type of PC connection with the PBX.
c.
Specify the settings as required.
Note
When connecting to the PBX for the first time selecting LAN, the IP Address and Port
Number must be set to 192.168.0.101 and 35300 respectively.
d.
Enter the system password for installer (default: 1234).
e.
Click Connect.
7. Follow the instructions of the Quick Setup wizard and assign the basic items (Quick Setup). After
Quick Setup is completed, if the IP addressing information was not changed and a V-IPEXT card
was installed during setup, the IP-PT registration screen is displayed. For information on registering
IP-PTs to the PBX, refer to "3.15 [1-1] Slot—Port Property - Virtual IP Extension" in the PC
Programming Manual. You may now begin programming the PBX.
Notice
•
During a long programming session, it is highly recommended that you periodically save the system
data to the SD Memory Card. If the PBX undergoes a sudden power failure or if the system is reset for
some reason, all the system data in RAM will be lost. However, if system data has been saved to the
SD Memory Card, it can be easily restored.
To save the system data to the SD Memory Card, (1) click the "SD Memory Backup" icon before
resetting the PBX or turning off the power, or (2) exit the Maintenance Console so that the PBX
automatically saves the system data.
•
When programming PBX data which can be displayed on a proprietary telephone (PT) (extension
names, group names, System Speed Dialing names, etc.), it is possible to enter characters which
cannot be displayed on a KX-DT300/KX-T7600 series PT. Characters which can be displayed on a
KX-DT300/KX-T7600 series PT are shown below in the white cells.
Document Version 2011-10
4.3.1 Installing and Starting the Maintenance Console
Installation Manual 153