Assembly And Adjustments - Craftsman 137.415020 Operator's Manual

ASSEMBLY AND ADJUSTMENTS


WARNING
!
For your safety, never connect plug
to power source receptacle until all
assembly and adjustment steps are
complete, and you have read and
understood the safety instructions.
ASSEMBLING THE WHEELS TO
STAND (FIG. A)
. Attach one wheel () to the leg using
the long hex bolt (2), the two flat
washers (3) and the lock nut (4), as
shown in Fig. A. Tighten the lock
nut (4) using a 4 mm wrench.
2. Repeat above step for the other
wheel to the other leg.
Fig. A
SETTING UP THE STAND
(FIG. B, C, D)
. Lift up the stand to upright position
as shown in Fig. B.
2. Unfold the left side set leg () by
releasing the locking levers (2) from
slot A to slot B, then rest the left side
of the stand onto the floor.
3. Release the hook (3) from the stop
screw.
4. Lift the right side frame of stand
slowly by the handle upward to its
highest position; the stand locking
handle (5) will rebound to left
automatically to secure the stand.
4 3

2
Fig. B

WARNING
!
To properly lock the stand, the
locking handle MUST be secured in
the slot on this cover plate (4).
Fig. C
3
Fig. D
1
9 9
Right Side
A
2
3

locking handle
release direction
6
SETTING UP
1 1
1
C
B
4
5