Craftsman 137.415020 Operator's Manual page 30

RIP FENCE INDICATOR
ADJUSTMENT (FIG. DD)
. The rip fence indicator () points to
the measurement scale. The scale
shows the distance from the side
of the fence to nearest side of the
blade.
2. Measure the actual distance with a
rule. If there is a difference between
the measurement and the indicator,
adjust the indicator ().
3. Loosen two screws (2) and slide
the indicator () to the correct
measurement on the scale. Tighten
two screws (2) and remeasure with
the rule.
Fig. DD
2

MITER GAUGE ADJUSTMENT
(FIG. EE)
. Loosen the lock handle () to allow
the miter body (2) to rotate freely.
Position the miter body at 90° so the
positive detent secures its position.
Tighten the lock handle to hold the
miter body in position.
2. If the pointer (3) requires adjustment,
loosen the screw under the pointer
with a screwdriver. Adjust the pointer
to 90° on the scale, then firmly
tighten the adjustment screw.
3. To change angles on the miter
gauge, loosen the lock handle ()
and rotate the miter body to the
desired angle as indicated by
the scale. Secure in position by
tightening the lock handle.
Fig. EE
2
TABLE INSERT ADJUSTMENT
(FIG. FF)
WARNING
!
To avoid serious injury, the table
insert (1) must be level with the
table. If the table insert is not flush
with the table, adjust the two
bolts (2) with a 4 mm hex wrench
until it is parallel with the table.
NOTE: To raise the insert, turn the hex
screws counterclockwise. To lower the
insert, turn the hex screws clockwise.
Do not remove the insert, adjustments
need to be made with the insert in
place to get the proper level.
Fig. FF
2
30 30

3