Recording; Basic Recording - JVC GR-DVF11 Instructions Manual

12
EN

Recording

Start/Stop Button
Display
25 min
min
90 min
(Now calculating)
0 min
(Blinking)
90
180
– – – – – – – – – –
BRIGHT 6
To Adjust The Brightness Of The Display
.... rotate MENU/BRIGHT until the brightness
indicator on the display moves and the
appropriate brightness is reached.
Power Switch
During shooting
Tape remaining time
indicator (Approximate)
3 min
89 min
1 min 2 min
(Blinking) (Blinking)
MENU/
BRIGHT Dial
Power Switch
Recording Start/Stop
Button
RECORDING
Shooting While Watching The
Viewfinder
NOTE:
You should already have performed the procedures listed
below. If not, do so before continuing.
Power ( pg. 6)
Load A Cassette (
Recording Mode Setting (
Grip Adjustment (
Viewfinder Adjustment (
1
Make sure the LCD monitor is closed and locked.
Press in the tabs on the lens cap to remove it, then set
the Power Switch to "
lights and the camcorder enters the Record-Standby
mode. "PAUSE" is displayed in the viewfinder.
2
Press the Recording Start/Stop Button. "
in the viewfinder while recording is in progress.
3
Press the Recording Start/Stop Button again to stop
recording. The camcorder re-enters the Record-
Standby mode.
Shooting While Watching The
LCD Monitor
Before the following steps, perform the procedures listed
in the above note.
1
Make sure the LCD monitor is fully open. Press in the
tabs on the lens cap to remove it, then set the Power
Switch to " " or "
the camcorder enters the Record-Standby mode.
"PAUSE" is displayed in the LCD monitor.
2
Tilt the LCD monitor upward/downward for best
viewability and press the Recording Start/Stop Button.
" " appears in the LCD monitor while recording is
in progress.
3
Press the Recording Start/Stop Button again to stop
recording. The camcorder re-enters the Record-
Standby mode.
NOTE:
When you use the LCD monitor outdoors in direct
sunlight, the LCD monitor may be difficult to see. If this
happens, use the viewfinder instead.

Basic Recording

pg. 9)
pg. 10)
pg. 11)
pg. 11)
" or " ". The power lamp
". The power lamp lights and
" appears