Yamaha YZFR1Y(C) 2009 Service Manual page 107

1. Upper air filter case
2. Fuel hose (secondary injector fuel rail side)
3. Fuel hose (primary injector fuel rail side)
4. Primary injector fuel rail
5. Sub-wire harness (secondary injector side)
6. Throttle cable (pull side)
7. Throttle cable (return side)
8. Black coating
9. White coating
10.Intake air pressure sensor
11.Accelerator position sensor
12.Plastic locking tie
13.Sub-wire harness (primary injector side)
14.Fuel damper
15.Injector #1 coupler
16.Injector #2 coupler
17.Injector #3 coupler
18.Injector #4 coupler
19.Cap
A. Checker color: orange
B. Checker color: black
C. Rotate the clip to the right of the vehicle.
D. Adjust top edge of the clip to top edge of
the paint.
E. Make sure the intake air pressure sensor is
touching against the stopper and install it
horizontally.
F. After installing the intake air pressure sen-
sor, do not press it to the direction of the
arrow.
G. Position the plastic locking tie as shown in
the illustration.
H. It is a cap for synchronization.
I. 30°
J. Mass of plastic locking ties
K. Mass of plastic locking ties should be
within this range.
L. 30°
2-70
CABLE ROUTING