Yamaha YZFR1Y(C) 2009 Service Manual page 512

c. Turn the main switch to "ON".
d. Measure the atmospheric pressure sensor
output voltage.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
EAS28390
CHECKING THE CYLINDER IDENTIFICA-
TION SENSOR
1. Remove:
• Fuel tank
Refer to "FUEL TANK" on page 7-1.
• Air filter case
Refer to "AIR FILTER CASE" on page 7-
5.
• Air filter case duct
Refer to "AIR INDUCTION SYSTEM" on
page 7-21.
2. Check:
• Cylinder identification sensor output volt-
age
Out of specification → Replace.
Cylinder identification sensor
output voltage (ON)
Less than 0.8 V
Cylinder identification sensor
output voltage (OFF)
More than 4.8 V
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Connect the test harness-speed sensor
(3P) "1" to the speed sensor coupler and
wire harness as shown.
b. Connect the pocket tester (DC 20 V) to the
test harness-speed sensor (3P).
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
Test harness-speed sensor (3P)
90890-03208
YU-03208
ELECTRICAL COMPONENTS
• Positive tester probe
White/Black (wire harness color)
• Negative tester probe
Black/Blue (wire harness color)
c. Turn the main switch to "ON".
d. Rotate the crankshaft.
e. Measure the voltage. With each full rotation
of the crankshaft, the voltage reading
should cycle from 0.8 V to 4.8 V to 0.8 V to
4.8 V.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
EAS28410
CHECKING THE INTAKE AIR PRESSURE
SENSOR
1. Check:
• Intake air pressure sensor output voltage
Out of specification → Replace.
Intake air pressure sensor out-
put voltage
3.57–3.71 V at 101.32 kPa
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Connect the test harness S-pressure sen-
sor 5S7 (3P) "1" to the intake air pressure
sensor and wire harness as shown.
ECA14B1035
Pay attention to the installing direction of
the test harness S-pressure sensor 5S7
(3P) coupler "a".
b. Connect the digital circuit tester (DCV) to
the test harness S-pressure sensor 5S7
(3P).
8-125