Yamaha YZFR1Y(C) 2009 Service Manual page 95

1. Union bolt
2. Washer
3. Exhaust chamber cover
4. Right footrest assembly
5. Brake caliper
6. Brake hose
7. Brake hose holder
8. Brake master cylinder
9. Footrest plate
10.Brake fluid reservoir hose
11.Clamp
12.Right muffler pipe cover
13.Pin
14.Washer
15.Cotter pin
A. 12–18 mm (0.47–0.71 in)
B. 6–12 mm (0.24–0.47 in)
C. Fit the lightening point of the brake light
within 6–12 mm (0.24–0.47 in) by adjusting
the adjusting nut of the rear brake light
switch.
D. Install the exhaust chamber cover to the
right footrest assembly by aligning it to the
bottom hole of the exhaust chamber cover.
E. Adjust the sag of the rear brake light switch
lead so that it is not outside of the right
footrest assembly.
F. When installing the rear brake caliper
bracket, make sure to fit the torque recep-
tor convex of the rear brake caliper bracket
and torque receptor groove of the swing-
arm.
G. Make sure to pass the brake hose through
the brake hose holder.
H. Face the clamp in the direction shown in
the illustration.
I. Make sure to bend the cotter pin. It can be
bent in the same direction.
J. Positioning of the exhaust chamber cover
and exhaust chamber upper cover is
shown in the illustration.
K. Projection of the right footrest assembly
L. When installing the exhaust chamber
cover, route the rear brake light switch lead
in front of the projection of the right footrest
assembly.
M. Install the brake hose with its paint mark
facing the brake master cylinder and
upward.
N. Route the brake fluid reservoir hose inside
of the brake hose.
O. Install the brake hose by contacting it
against the stopper.
P. Route the rear brake light switch lead
between the ribs of the exhaust chamber
cover.
Q. Route the rear brake light switch lead
between the top and bottom frame bosses
for installing the right footrest assembly
and to inside of the frame.
2-58
CABLE ROUTING