Advertisement
Advertisement
Cordless Lawn mower equipped with rotary blade cutting system. Its main benefits are: • Environment-friendly with zero emission and minimum noise pollution • Compatible with both Makita 36V-2.6Ah Li-ion battery BL3626 Dimensions: mm (inch) and 36V-2.2Ah Li-ion battery BL3622A minimum...
P 2/ 8 epair CAUTION: Repair the machine in accordance with “Instruction manual” or “Safety instructions”. [1] NECESSARY REPAIRING TOOLS Code No. Description Use for 1R285 Round bar for Arbor 11-50 removing Plane bearing 10 from Front/ Rear wheels [2] ASSEMBLY/ DISASSEMBLY [2]-1.
P 3/ 8 epair [2] ASSEMBLY/ DISASSEMBLY [2]-1. Handle section (cont.) ASSEMBLING Assemble Handle section in the reverse order of disassembly. Note: • Face the top of Lever to the upper side when assembling Lever to Switch lever. (Fig. 7) While holding the insert nut on lever so as not to separate, assemble Lever to Switch lever with M4x20 Pan head screw with WR.
P 4/ 8 epair [2] ASSEMBLY/ DISASSEMBLY [2]-2. Motor section REPLACING (1) Remove Blade. (2) Pull Lock lever to release the locking of Battery cover complete, and then open Battery cover complete. (Fig. 11) Remove the hinge of one side carefully, and separate it from Cowling. (Fig. 12) And then, remove the other hinge in the same way.
P 5/ 8 epair [2] ASSEMBLY/ DISASSEMBLY [2]-3. Change lever section DISASSEMBLING (1) Remove Cowling. (Refer to the previous page.) (2) Shift Change lever to the position of grass cutting height 75mm. (3) Detach the hook of Tension spring 16 from the projection of Deck using long-nose pliers. (Fig. 17) (4) Put a wood under Deck to raise Wheels from the ground.
P 6/ 8 epair [2] ASSEMBLY/ DISASSEMBLY [2]-4. Wheels DISASSEMBLING (1) Pull Front wheel caps straight out of Front wheels. (Fig. 22) Remove Rear wheel caps in the same way. (2) Remove M8 Collared hex nuts and Front wheels from Front shaft. (Fig. 23) Separate Rear wheels from Rear shaft in the same way.
P 7/ 8 epair Fig. 30 [2] ASSEMBLY/ DISASSEMBLY [2]-5. Connecting rod, Shafts (cont.) Rear shaft ASSEMBLING Front shaft Assemble each wheel section in the reverse order of disassembly. Distinguish Front shaft from Rear shaft by the white paint. (Fig. 30) white paint ircuit diagram Fig.
P 8/ 8 iring diagram (cont.) Fig. D-3 To Switch Terminal Fix Lead wires (black, white) in these Lead wire holders. Connect Flag receptacles as drawn above. Be careful to the directions. Lead unit Controller Fix Lead wires (red, blue) in these Lead wire holders.
Comments to this Manuals
Latest comments: