Makita BLM430 Technical Information page 5

R
epair
[2] ASSEMBLY/ DISASSEMBLY
[2]-3. Change lever section
DISASSEMBLING
(1) Remove Cowling. (Refer to the previous page.)
(2) Shift Change lever to the position of grass cutting height 75mm.
(3) Detach the hook of Tension spring 16 from the projection of Deck using long-nose pliers. (Fig. 17)
(4) Put a wood under Deck to raise Wheels from the ground. (Fig. 18)
(5) Unscrew two 4x18 Tapping screws, and separate the pin of Connecting rod from the hole of Change lever,
and then remove Change lever section from Deck toward DC motor side. (Fig. 19)
(6) Remove Change lever cover, and then separate screws, bolt and nut as drawn in Fig. 20.
ASSEMBLING
Assemble Change lever section in the reverse order of disassembly.
Note: Lift Connecting rod and insert the pin into the hole of Connecting rod. (Fig. 21)
Fig. 17
Change lever
hook of
Tension
spring 16
Long-nose
pliers
Fig. 18
Wood
projection of Deck
Fig. 20
Flat washer 4
4x18 Tapping
screw
M6 Hex nut
4x18 Tapping
screw (2 pcs.)
Fig. 21
hole of Change lever
Fig. 19
Adjust plate
Change lever
Compression spring 9
Flat washer 9
Adjust plate
Connecting rod
pin of Connecting rod
P 5/ 8
4x18 Tapping screw
(2 pcs.)
Change lever
Change
lever
cover
Sleeve 6
M6x30
Hex bolt