Blank Search - JVC GR-D20 Instructions Manual

NOTES:
If Stop mode continues for 5 minutes when power is
supplied from a battery, the camcorder shuts off
automatically. To turn on again, set the Power Switch
to "OFF (CHARGE)", then to "PLAY".
The playback picture can be viewed in the LCD monitor,
viewfinder or on a connected TV (
You can also view the playback picture on the LCD
monitor with it flipped over and pushed against the
camera body.
LCD monitor/viewfinder indications:
When power is supplied from a battery: the "
pack remaining power indicator is displayed.
When power is supplied from an AC outlet: "
not appear.
When a cable is connected to the AV connector, the
sound is not heard from the speaker.
If still playback continues for more than about 3 minutes,
the camcorder's Stop mode is automatically engaged.
6
When 4/6 is pressed to engage still playback, the
image may not pause immediately while the camcorder
stabilises the still image.
EN
14
TAPE PLAYBACK
Helps you find where you should start recording in the
y
middle of a tape to avoid time code interruption
(
1
pg. 15).
2
down the Lock Button
3
" battery
• "BLANK SEARCH"
" does
To cancel Blank Search midway . . .
..... press 5
NOTES:

Blank Search

pg. 13).
Load a tape ( pg. 9).
Set the Power Switch
t
Press BLANK SEARCH
r
appears and the camcorder
automatically starts reverse or forward shuttle search,
then stops at the spot which is about
3 seconds of tape before the beginning of the
detected blank portion.
4
.
In step 3, if the current position is at a blank portion the
camcorder searches in the reverse direction, and if the
current position is at a recorded portion the camcorder
searches in the forward direction.
Blank Search does not work if "HEAD CLEANING
REQUIRED. USE CLEANING CASSETTE" has appeared
with the tape.
If the beginning or end of the tape is reached during
Blank Search, the camcorder stops automatically.
A blank portion which is shorter than 5 seconds of tape
may not be detected.
The detected blank portion may be located between
recorded scenes. Before you start recording, make sure
there is no recorded scene after the blank portion.
t
y
y
to "PLAY" while pressing
located on the switch.
&
.
&