Connecting The Speakers; Connecting Front Cube Speakers To Tile Acoustimass Module - Bose Acoustimass 6 Series Owner's Manual

= I\lever connect the cube speakers direct/y to a receiver output. Always connect
e powered AcouslirnassO module, then connect the module to the receiver.
Never use broken or frayed wiring, which can result in electrical shock or damage
to your system. The supplied cables are not intended for in-wall installafion. Check local
building codes or enlist a qualified insfaIler.
Cube speaker connections
to Rcousfimass module
8
Connecting the speakers
A
CAUTION: Never connect the cube speakers directly to a receiver output. Always connect
them to the powered AcoustimasEf& module, then connect the module to the receiver.
A
CAUTiON: Never use broken or frayed wiring, which can result in electrical shock or damage
to your system. The supplied cables are not intended for in-wall installation. Check local
building codes or enlist a qualified installer.
Connecting front speakers
to
the Acoustimass module
Three individual 20-foot (6.1 m) speaker cables connect the center, right, and left front cube
speakers to the Acoustimass module (Figure 5). Be sure to match the correct cable with the
corresponding speaker location. Front speaker cables have blue RCA connectors at one end
with l (left), R (right), or C (center) molded into the connectors. The other ends of the cables
have two wires. The red collars on the
+
wire are labeled lEFT, RIGHT, or CENTER.
Cube speaker connections
to Acoustimass module
8
RIGHT
REAR
LEFT
LEFT
REAR