Summary of Contents for Bose Acoustimass 6 Series III
Page 1
Acoustimass ® Series III Acoustimass ® Series IV H O M E E N T E R T A I N M E N T S P E A K E R S Y S T E M S !"#$%&'()*+,$ )*-.(,$(*'.%+/ 0/1+2$(,&*1+3+'.1+/#...
Français Español English ETTING Before you begin We appreciate your choice of the Bose ® Acoustimass ® 6 Series III or Acoustimass 10 Series IV home entertainment speaker system. The Acoustimass 6 features five small cube speakers, while the Acoustimass 10 system features four cube speaker arrays and a center front speaker.
To prevent this problem, rubber feet are provided for attachment to the bottom of the center front speaker. Note: You may order additional rubber feet, free of charge, by contacting Bose. Refer to the address list included in the carton.
Français Español English ETTING Front left and right speakers The goal for these is to create a sound image wider than the screen that seems natural to viewers sitting anywhere in the room. • Place these two front speakers on either side of your TV. •...
English Español Français ETTING Powered Acoustimass module ® Acoustimass ® speaker technology makes it difficult to locate the source of low-frequency sound from this module. So feel free to hide it from view, and: • Locate the module at the same end of the room as the TV screen. •...
Page 8
Français Español English ETTING 2. Use the supplied 50-ft (15.2 m) speaker cables for the speakers at the rear of your room (Figure 5). Insert them into the jacks on the module as follows: • RR goes into the jack labeled Right Rear. •...
English Español Français ETTING Connecting the Acoustimass ® module to the receiver The system input cable is 20 feet (6.1 m) long and connects to your surround receiver. Unlike the speaker cables, this input cable has a multi-pin connector that inserts into the Audio Input jack on the module (Figure 6).
When all the connections check out, plug the power cord from the Acoustimass module into an AC (mains) outlet. Plug in the receiver also. Note: Bose recommends using a quality surge suppressor on all electronics equipment. Voltage variations and spikes can damage electronic components in any system. Using a high- quality suppressor (available at electronics stores) can eliminate the vast majority of failures caused by a power surge.
English Español Français SING YSTEM Getting the most from your home theater speakers ® With system connections completed and the module plugged in, your Acoustimass system is now ready for use. You may want to familiarize yourself with the controls and built-in protections that adjust ! the audio of this system (Figure 9).
Français Español English SING YSTEM Setting your digital surround sound receiver 6 Series III or Acoustimass 10 Series IV system are fully ! ® Speakers in your Acoustimass compatible with the audio output of digital surround receivers. The system’s integrated signal processing supports full low-frequency reproduction from all channels.
® and try the following solutions. If you still have a problem, contact your Bose dealer to arrange for service. To contact Bose directly, refer to the address list included in the carton. Problem What to do System does not function •...
Details! of the warranty are provided on the warranty card that came with your system. Please fill out the information section on the card and mail it to Bose. Failure to do so, ! however, does not affect your rights.
English Español Français EFERENCE Technical information Speaker driver complement Acoustimass ® 10 system: • Cube speaker arrays and center front speaker: Two 2.5" (6.35 cm) Twiddler speakers • Powered Acoustimass module: Two 5.25" (13 cm) woofers Acoustimass 6 system: • Cube speakers: One 2.5"...