Configuring The Switch To Access A Radius Server - HP ProCurve 2510G Series Manual

Configuring the Switch To Access a
RADIUS Server
RADIUS Server Configuration Commands
radius-server
i
[host < p-address>]
[key < global-key-string >]
i
radius-server host < p-address> key <server-specific key-string>
This section describes the minimal commands for configuring a RADIUS
server to support Web-Auth and MAC Auth. For information on other RADIUS
command options, refer to chapter 5, "RADIUS Authentication, Authorization
and Accounting" .
Syntax: [no] radius-server
[host < ip-address >]
Adds a server to the RADIUS configuration or (with no)
deletes a server from the configuration. You can config-
ure up to three RADIUS server addresses. The switch uses
the first server it successfully accesses. (Refer to
"RADIUS Authentication, Authorization
and Accounting" on page 5-1.)
[key < global-key-string >]
Specifies the global encryption key the switch uses with
servers for which the switch does not have a server-
specific key assignment (below). This key is optional if
all RADIUS server addresses configured in the switch
include a server-specific encryption key. (Default: Null.)
Web and MAC Authentication

Configuring the Switch To Access a RADIUS Server

below
below
3-16
3-15