HP ProCurve 2510G Series Manual page 294

Configuring and Monitoring Port Security
Configuring Protected Ports
9-38
ProCurve(config)# protected-ports 7
Must have at least 2 ports configured as protected.
ProCurve(config)# protected-ports 7,8
Figure 9-20. Example of Protected Ports Command
To display information about which ports have been configured as protected
ports, enter this command:
ProCurve(config)# show protected-ports
ProCurve(config)# show protected-ports
Protected-ports
Unprotected-ports: 1-6,9-48
Figure 9-21. Example Showing Protected Ports and Unprotected Ports
If you display the running config file (show running-config) you will see the
ports that have been selected as protected ports.
ProCurve(config)# show running-config
Running configuration:
; J9280A Configuration Editor; Created on release #Y.11.XX
hostname "ProCurve Switch 2510G-48"
snmp-server community "public" Unrestricted
vlan 1
name "DEFAULT_VLAN"
untagged 1-48
ip address dhcp-bootp
exit
protected-ports 7-8
Figure 9-22. Example of Running Config File Showing Protected Ports
Must configure at least two ports
: 7-8