Operator Safety Instructions - Alto Carpetmaster 577 Operator's Manual

WARNING
DANGER:
WARNING:
CAUTION:
DANGER:
DANGER:
DANGER:
DANGER:
DANGER:
WARNING:
WARNING:
WARNING:
CLARKE TECHNOLOGY Operator's Manual 577 Carpetmaster

OPERATOR SAFETY INSTRUCTIONS

AVERTISSEMENT
Failure to read and observe all DANGER statements could result in
severe bodily injury or death. Read and observe all DANGER
statements found in your Owner's Manual and on your machine.
Failure to read and observe all WARNING statements could result
in injury to you or to other personnel; property damage could
occur as well. Read and observe all WARNING statements found in
your Owner's Manual and on your machine.
Failure to read and observe all CAUTION statements could result in
damage to the machine or to other property. Read and observe all
CAUTION statements found in our Owner's Manual and on your
machine.
Failure to read the Owner's Manual prior to operating or attempting any service or
maintenance procedure to your machine could result in injury to you or to other
personnel; damage to the machine or to other property could occur as well. You
must have training in the operation of this machine before using it. If you or your
operator(s) cannot read English, have this manual explained fully before attempting
to operate this machine.
Operating a machine that is not completely or fully assembled could result in injury
or property damage. Do not operate this machine until it is completely assembled.
Inspect the machine carefully before operation. Do not use as a step or furniture,
the machine could move causing injury.
Machines can cause an explosion when operated near flammable materials and
vapors. Do not use this machine with or near fuels, grain dust, solvents, thinners,
or other flammable materials.
Using a machine with a damaged power cord could result in an electrocution. Do
not use the machine if the power cord is damaged. To prevent damage to the
power cord, do not let the brush touch the power cord when the machine is
running. Always lift the power cord over the machine. Do not use the electrical
cord to move the machine.
Electrocution could occur if maintenance and repairs are performed on a unit that
is not disconnected from the power source. Disconnect the power supply before
changing the brush or accessories or attempting any maintenance or service.
Maintenance and repairs must be done by authorized personnel.
Operating a machine without observing all labels and instructional information could
result in injury or damage. Read all machine labels before attempting to operate. Make
sure all of the labels and instructional information are attached or fastened to the ma-
chine. Get replacement labels and plates from your Clarke Technology distributor.
Always use a three-wire electrical system connected to the electrical ground. For
maximum protection against electric shock, use a circuit that is protected by a ground
fault circuit interrupter. Consult your licensed electrician and/or contact your local
Clarke Technology distributor for assistance.
To prevent electrical shock, do not use this machine on wet surfaces. Protect the
machine from rain, Keep the machine in a dry building. Always clean the machine with
a clean dry cloth.
ADVERTENCIA
Page 3