Ipv6 - Draytek Vigor 2110 User Manual

4 . 1 . 5 I P v 6
4 . 1 . 5 I P v 6
During the procedure of IPv4 PPPoE connection, we can get the IPv6 Link Local Address
between the gateway and Vigor router through IPv6CP. Later, use DHCPv6 or Accept RA to
acquire the IPv6 prefix address (such as: 2001:B010:7300:200::/64) offered by the ISP. In
addition, PCs under LAN also can have the public IPv6 address for Internet access by means
of the generated prefix.
I P v 6 – P P P
I P v 6 – P P P
No need to type any other information for PPP mode.
Note: At present, the IPv6 prefix can be acquired via the PPPoE mode connection which
is available for the areas such as Taiwan (hinet), the Netherlands, Australia and UK.
I P v 6 – T S P
I P v 6 – T S P
Tunnel setup protocol client (TSPC) is an application which could help you to connect to IPv6
network easily.
Please make sure your IPv4 WAN connection is OK and apply one free account from hexago
(http://gogonet.gogo6.com/page/freenet6-account ) before you try to use TSPC for network
connection. TSPC would connect to tunnel broker and requests a tunnel according to the
specifications inside the configuration file. It gets a public IPv6 IP address and an IPv6 prefix
from the tunnel broker and then monitors the state of the tunnel in background.
After getting the IPv6 prefix and starting router advertisement daemon (RADVD), the PC
behind this router can directly connect to IPv6 the Internet.
C
C
94
Vigor2110 Series User's Guide